proper spot on the center nut

. You may be required to rotate the plastic horn tube in order to properly align the hub in the necessary position.Detach the steering wheel by removing the nut-shaft.Take the plastic sleeve and spring, and re-insert them into the horn housing. Fasten the hub to the steering column once the wheel is in the correct position. Alternatively, you can remove the horn fuse from the fuse box.Re-connect the lead wire to the connector. Press down on the center of your car accessories steering wheel cover steering wheel to depress the horn cap.

Place the hub over the shaft, lining up the shaft with the previously applied mark. This is done so you can make sure the steering column is properly lined up when you replace the nut-shaft.Place a mark on the shaft.Before working on the car you should disconnect the battery.Disconnect the horn wire or the connecting mechanism. This should be placed at the 12 o?clock position. Position the spring in its proper spot on the center nut. Do this in order to prevent the horn from sounding while you work on the steering wheel. To do this, you will need to pull it off or pry it loose.Pull off the hub of the previous steering wheel, using a pliers or a puller.Insert the new wire lead into the plastic sleeve.

Once finished, re-install the shaft nut retaining clip next.Place the new wheel on the column, feeding the new wire through the center holes. Installing the New WheelPlace the metal sleeve over the steering column.Re-attach the shaft nut. Next you can remove the old steering wheel. Turn the cap until it properly tightened.Removing the Old Wheel Orientate your vehicle so the wheels are pointing straight ahead. Properly align the new wheel. Tighten the nut and shoulder bolts.Re-connect the battery, or re-install the horn fuse. Re-align the horn cap and push it back into place. Save this sleeve for later. Then twist the cap or ring and remove the horn emblem cap. Next, insert this assembly into the housing and lock it into the proper position.Next, remove the horn mechanism. If this is the case you will need to unscrew them prior to removing the cap. Your horn cap may be attached by the use of screws. The larger end should come into contact with the horn housing. When disconnecting the horn, you may be forced to clip the wire below the plastic sleeve